The first step: set the lamp

So-called set lamp is according to the width of the road, road facilities to the height of the street lamp, lamp pole diameter size, light wattage and the distance between two adjacent street lamp design, the final roads which need the number of street lamp, to ensure that the street lamp illuminant irradiation distance "impartiality", make its radiation within the required range.

modular street light The second step: digging ditches

The trench is used for embedded, so-called embedded parts is our mouth often mentioned in the cage. And earth cage thickness of steel bars and the whole cage, size are the dimensions of the height and weight of the light pole. The higher the road lights, light pole is heavier, the corresponding embedded parts of the road lights (cage). So when installing road lights, according to design good road conditions can be set out at the end of the lamp lamp on digging ditches.

The third step: buried pipe

So-called buried pipe is in preparation for the street lamp linear power supply, later buried by good line cable, since the role to protect the cables in the ground, durable, corrosion resistant.

The fourth step: pouring street lamp base

The so-called pouring street lamp base is made with cement concrete foundation to consolidate, stable lamps do.

Step 5: laying cables

According to the buried piping and cable, in order to supply electricity demand of street lighting.

Step 6: insulation test

After a good cable laying, insulation test, whether electric current facilities comply with safety standards.

Step 7: street lamp installation

Install the lamp on the embedded parts ready to be fixed

Step 8: electrical equipment installation

Fix the assembled street lamp at a predetermined light pole height to their location, installation.

Step 9: experiment and debugging

After all installation, can be carried out on the street lamp test, debug, test whether street lamp lighting according to the rules, for example: light intensity is normal, whether lighting time according to the set time to work, etc.

Step 10: self-inspection

Can check again the street lamp, lamp unit to confirm all lights are working.

Step 11: completion inspection and acceptance

After the above inspection steps are to correct before completion inspection and acceptance, a formal streets to put into use.

Perhaps you that on the one hand, there are a lot of doubt for street lighting, hope can provide service for you. We are Luminhome Lighting, www.luminhome.com